Ultrapure Water Membrane

 

ztec-e.jpg

Pleated Polyethersulfone (PES) Membrane for

Final Filtration of Ultrapure Water

ZTEC-E microelectronics grade cartridges represents the latest latest development in ultrapure water filtration technology. The filters are inherently hydrophilic and contain no added surfactants or wetting agents that could contaminate pure and ultrapure water streams. The PES membrane offers superior flow characteristics, high contaminant capacity and consistent removal of sub-micron particles. The cartridges exhibit rapid rinse-up to 18 MW-cm resistivity and single digit ppb levels of TOC.

Filter Features–Benefits

• Manufactured, flushed, tested and packaged, in an ISO Class 7 Cleanroom Environment.
• Filters are100% flushed with 18 MW-cm DI water and integrity tested.
• Resistivity rinse-up to 18 MW-cm and single digit ppb TOC levels in less than 30 minutes at 3 gpm per        10-inch element.
• Available in a variety of end cap/adapter configurations to fit all industry-standard housings.
• Pore size, lot and serial number are stamped on each filter element for identification and traceability.

 

Filter Specifications

  • Media: Asymmetric Polyethersulfone membrane
  • Inner core, end caps, cage: Polypropylene
  • Support layers: Spunbonded Polypropylene
  • Gaskets/O-Rings: Buna-N, EPDM, Silicone, Viton, TeflonEncapsulated Viton O-Rings
  • Micron ratings: 0.03 μm, 0.1 μm, 0.2 μm, 0.45 μm

 

Dimensions and Operating Parameters

  • Nominal lengths: 9.75’’ 10’’, 20’’, 30’’, 40’’
  • Outside diameter: 2.7’’ (6.9 cm)
  • Inside diameter: 1.0’’ (2.54 cm)
  • Surface area: 7.7 ft.2 (0.7 m2) per 10-inch element
  • Maximum 60 psid @ 80°F (4.14bar @ 27°C)
  • differential pressure: 30 psid @ 160°F (2.07 bar @ 71°C)
  • 15 psid @ 203°F (1.03 bar @ 95°C)
  • Maximum reverse differential pressure: 40 psid @ 70°F (2.8 bar @ 21°C)
  • Recommended changeout pressure: 40 psid (2.76 bar)